Z Corporation Z 406 User Manual download pdf (Page 104)

Z Corporation Z406 System User Manual

104 Z Corporation Service (781)852-5050/(877)88-ZCORP

2. Depowder the part and the fixture.

3. Remove part from build plate and place on a clean surface. Then separate the part

from the fixture.

4. Apply a silicone mold release (such as IMS Paintable Neutral Oil Mold Release –

www.imscompany.com

or Hapco GREASE-IT FDG - www.hapcoweb.com) liberally

onto the top surface of the fixture where the part will make contact with the fixture.

This is done to prevent the infiltrated part from adhering to the fixture during the

infiltration process.

5. Gently apply Z-Snap or Z-Max epoxy to the bottom surface of the part and carefully

place the part back onto the fixture.

6. Apply Z-Snap or Z-Max epoxy to the rest of the part. Do not apply excess epoxy as

pooling will occur. Several thin coats are better than one thick coat.

Use a paper

towel or tissue paper to remove excess epoxy that may have pooled on the surface

of the part.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 156 157

No comments

Z Corporation Z 406 User Manual Page 104