Z Corporation Z 406 Owner's Manual download pdf (Page 18)

PLEASE NOTE: In the process of

changing the location or orientation of a

part, you may find that parts overlap in

the build box or exceed the boundaries of

the build box. If parts exceed the

boundaries of the build box, the System

Software will alert you with an error

message and the part in question will be

outlined in red unless this feature has

been disabled under Preferences. To fix

the problem, select the part and either

move it within the build box or use the

‘Justify’ feature to bring the part

completely within the build box. You will

need to rescale your part if it does not fit

into the build box after justification.

If parts overlap with each other in the

build box, you will NOT receive an error

message unless you choose to run the

‘Collision Detection’ feature under the

View menu. The feature will take a few

minutes to process the build. A dialog

box will appear when the software

detects a part overlap. It will let you know

if there was a collision and where the

collision was detected. After fixing the

part overlap, carefully inspect the build

box by checking the layers of the build.

Press the A or Z key to move through

each layer. Then rerun the Collision

Detection function.

service@zcorp.com

18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments