Z Corporation Z 406 User Manual download pdf (Page 73)

ZPrint™ Software Manual The Printer Status Dialog (ZPrinter 350/450/650

11/30/09

7.3 Change Print Heads

ZPrint checks the status of the print head(s) before every build. If a print head needs to be changed, ZPrint

displays CHANGE PRINT HEAD in the Printer Status dialog. You will not be able to start the build until

you have changed the appropriate print head.

• Do not change the print head(s) unless prompted to in the Printer Status dialog.

• When the HP11 print head is changed, the printer runs an automatic purge cycle to clear the print

head of its black ink and prepare it for clear binder.

• When a color print head is replaced, or removed from its slot for cleaning, the printer will run the

Auto-Alignment pattern to properly align the print heads before the next build is started.

NOTE: The instructions below are a general summary of the actual steps required. The steps will vary

somewhat depending on the printer you are using. Refer to the Hardware Manual for your printer.

1. Select

PRINT HEAD > CHANGE PRINT HEAD on the printer LCD menu. The Fast Axis moves to

the service position.

2. Open the printer top cover and then open the carriage cover.

3. Lift the print head out of its slot and properly dispose of any empty cartridge(s).

4. Open an alcohol swab (included with your Startup Kit), and squeeze the tube to saturate the swab.

5. Wipe off the pogo pins (inside the carriage) with the alcohol swab.

6. Wet a paper towel with distilled water and clean the underneath of the carriage, as specifically appro-

priate for your printer. When finished, press

CONTINUE on the LCD.

Important: Clean the underneath of the carriage every time you change a print head, and no less than

every 3-6 weeks depending on your machine usage. Residue buildup on the underside of the carriage

could result in print head errors (such as 40006, or 2303:1).

7. Remove all new cartridge packaging. Be sure to pull the tape tab off of the new cartridge.

8. Insert each new cartridge. Press down firmly on the side of the cartridge nearest the pogo pins to

securely fit the cartridge into its slot.

9. Close the carriage cover by pressing down until you hear the cover click shut.

10. Close the printer top cover and then press Continue > Exit on the LCD.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 98 99

No comments

Z Corporation Z 406 User Manual Page 73